Specifications

5-164
Cisco IOS Telephony Service, Version 2.02
Chapter 5 Command Reference
voicemail (telephony-service)
voicemail (telephony-service)
To configure the telephone number that is speed-dialed when the message button on a Cisco IP phone is
pressed, use the voicemail command in telephony-service configuration mode. To disable the messages
button, use the no form of this command.
voicemail phone-number
no voicemail
Syntax Description
Defaults No phone number is configured and the messages button is ineffective.
Command Modes Telephony-service configuration
Command History
Usage Guidelines The voicemail command configures the telephone number that is speed-dialed when the message button
on a Cisco IP phone is pressed. The same telephone number is configured for voice mail for all
Cisco IP phones connected to the router.
The default behavior is that no phone number is configured and the messages button is ineffective.
Examples The following example shows that the phone number 914085551000 is set as the speed-dial number that
is dialed to retrieve messages when the messages button is pressed:
Router(config)# telephony-service
Router(config-telephony-service)# voicemail 914085551000
The number 914085551000 is called when the Cisco IP phone messages button is pressed to retrieve
messages.
phone-number The phone number that is configured as a speed-dial number to retrieve
messages.
Release Modification
12.1(5)YD This command was introduced on the following platforms:
Cisco 2600 series and Cisco 3600 series multiservice routers, and
Cisco IAD2420 series IADs.
12.2(2)XT This command was implemented on the Cisco 1750 and
Cisco 1751 multiservice routers.
12.2(8)T This command was integrated into Cisco IOS Release 12.2(8)T and
implemented on the Cisco 3725 and Cisco 3745 routers.
12.2(8)T1 This command was implemented on the Cisco 2600-XM and Cisco 2691
routers.
12.2(11)T This command was integrated into Cisco IOS Release 12.2(11)T and
implemented on the Cisco 1760 routers.