Specifications

5-147
Cisco IOS Telephony Service, Version 2.02
Chapter 5 Command Reference
telephony-service
telephony-service
To enable Cisco IOS Telephony Service and enter telephony-service configuration mode, use the
telephony-service command in global configuration mode. To disable Cisco IOS Telephony Service, use
the no form of this command.
telephony-service
no telephony-service
Syntax Description This command has no arguments or keywords.
Defaults No default behavior or values.
Command Modes Global configuration
Command History
Usage Guidelines The telephony-service command is the top-level command for all other commands related to Cisco IOS
Telephony Service configuration.
Examples The following example shows how to enter telephony-service configuration mode:
Router(config)# telephony-service
Router(config-telephony-service)#
Related Commands
Release Modification
12.1(5)YD This command was introduced on the following platforms:
Cisco 2600 series and Cisco 3600 series multiservice routers, and
Cisco IAD2420 series IADs.
12.2(2)XT This command was implemented on the Cisco 1750 and
Cisco 1751 multiservice routers.
12.2(8)T This command was integrated into Cisco IOS Release 12.2(8)T and
implemented on the Cisco 3725 and Cisco 3745 routers.
12.2(8)T1 This command was implemented on the Cisco 2600-XM and Cisco 2691
routers.
12.2(11)T This command was integrated into Cisco IOS Release 12.2(11)T and
implemented on the Cisco 1760 routers.
Command Description
dialplan-pattern Creates a global prefix that can be used to expand the abbreviated extension
numbers into fully qualified E.164 numbers.
ephone Enters ephone configuration mode to register Cisco IP phones.