Specifications

5-126
Cisco IOS Telephony Service, Version 2.02
Chapter 5 Command Reference
show ephone-dn
show ephone-dn
To display a Cisco IP phone destination number of the Cisco IOS Telephony Service router, use the show
ephone-dn EXEC command.
show ephone-dn [tag | summary]
Syntax Description
Command Modes EXEC
Command History
Examples The following is sample output from the show ephone-dn command:
Router# show ephone-dn 1
EFXS 50/0/1 Slot is 50, Sub-unit is 0, Port is 1
Type of VoicePort is EFXS
Operation State is UP
Administrative State is UP
No Interface Down Failure
Description is not set
Noise Regeneration is enabled
Non Linear Processing is enabled
Music On Hold Threshold is Set to -38 dBm
In Gain is Set to 0 dB
Out Attenuation is Set to 0 dB
Echo Cancellation is enabled
Echo Cancel Coverage is set to 8 ms
Playout-delay Mode is set to default
Playout-delay Nominal is set to 60 ms
Playout-delay Maximum is set to 200 ms
Connection Mode is normal
Connection Number is not set
Initial Time Out is set to 10 s
tag (Optional) Destination number tag. The destination number can be from 1
to 24.
summary (Optional) Summary of all Cisco IP phone destination numbers.
Release Modification
12.1(5)YD This command was introduced on the following platforms:
Cisco 2600 series and Cisco 3600 series multiservice routers, and
Cisco IAD2420 series IADs.
12.2(2)XT This command was implemented on the Cisco 1750 and
Cisco 1751 multiservice routers.
12.2(8)T This command was integrated into Cisco IOS Release 12.2(8)T and
implemented on the Cisco 3725 and Cisco 3745 routers.
12.2(8)T1 This command was implemented on the Cisco 2600-XM and Cisco 2691
routers.
12.2(11)T This command was integrated into Cisco IOS Release 12.2(11)T and
implemented on the Cisco 1760 routers.