Specifications

5-54
Cisco IOS Telephony Service, Version 2.02
Chapter 5 Command Reference
ephone
Usage Guidelines This is a top-level command used to configure Cisco IP phones on the Cisco IOS Telephony Service
router. By default, no Cisco IP phone is configured. Therefore, you must manually enter the number of
Cisco IP phones you need to configure in your network by entering the max-ephones and max-dn
commands.
Examples The following example shows how to enter ephone configuration mode for phone 4:
Router(config)# ephone 4
Router(config-ephone)#
Related Commands Command Description
button Assigns a button number to the Cisco IP phone directory number.
ephone-dn Enters ephone-dn configuration mode and configures the directory numbers
for the Cisco IP phone lines.
mac-address Configures the MAC address of the Cisco IP phone
max-dn Sets the maximum number of directory numbers that can be supported by
the router.
max-ephones Configures the maximum number of Cisco IP phones that can be supported
by the router.
paging-dn Sets audio paging directory number for each Cisco IP phone.
reset Resets the Cisco IP phones in ephone configuration mode.
speed-dial Sets speed-dial buttons on a Cisco IP phone.
telephony-service Enables Cisco IOS Telephony Service and enters telephony-service
configuration mode.
username Assigns a phone user login account username and password to permit user
login to the Cisco IOS Telephony Service router through a web browser.
vm-device-id Defines a voice-mail ID string.