Installation guide

5-3

Cisco Access Router Manager Installation Guide

OL-3598-02

Chapter 5 Getting Started

Starting a User Session

Starting the Cisco EMF manager system automatically starts the EM.

To start the Cisco EMF manager system, follow these steps.

Step 1 Ensure that Cisco EMF is running. For further information, see the “Checking the Status of the EM”

section on page 5-2.

Note If Cisco EMF is already started, proceed to step 4.

Step 2 Log in as a root user.

Step 3 Start the Cisco EMF manager system by entering the following:

CEMF_ROOT/bin/cemf start

(Replace CEMF_ROOT with the name of the directory where Cisco EMF is installed.)

The Cisco EMF and EM processes start.

Any type of user (not only root users) can start a Cisco EMF user session.

Step 4 To start a Cisco EMF/EM user session, enter commands as follows:

CEMF_ROOT/bin/cemf session

(Replace CEMF_ROOT with the name of the directory where Cisco EMF is installed.)

Step 5 Enter a username and a password. (The default username is admin, and the default password is admin.)