Hardware manual

link-test
Interface Commands IR-133
link-test
To reenable the link-test function on a port on an Ethernet hub of a Cisco 2505 or Cisco 2507, use
the link-test hub configuration command. Use the no form of this command to disable this feature
if a pre-10BaseT twisted-pair device not implementing link test is connected to the hub port.
link-test
no link-test
Syntax Description
This command has no arguments or keywords.
Default
Enabled
Command Mode
Hub configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 10.3.
This command applies to a port on an Ethernet hub only. Disable this feature if a 10BaseT
twisted-pair device at the other end of the hub does not implement the link test function.
Example
The following example disables the link test function on hub 0, ports 1 through 3:
hub ethernet 0 1 3
no link-test
Related Commands
You can use the master indexes or search online to find documentation of related commands.
hub