Hardware manual

lex priority-group
Interface Commands IR-129
lex priority-group
Use the lex priority-group interface configuration command to activate priority output queuing on
the LAN Extender. To disable priority output queuing, use the no form of this command.
lex priority-group group
no lex priority-group
Syntax Description
Default
Disabled
Command Mode
Interface configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 10.3.
To define queuing priorities, use the priority-list protocol global configuration command. Note that
you can use only the following forms of this command:
priority-list list protocol protocol {high | medium | normal | low}
priority-list list protocol bridge {high | medium | normal | low} list list-number
If you specify a protocol that does not have an assigned Ethernet type code, such as x25, stun, or
pad, it is ignored and will not participate in priority output queuing.
Example
The following example activates priority output queuing on LAN Extender interface 0:
priority-list 5 protocol bridge medium list 701
lex interface 0
lex priority-group 5
Related Commands
You can use the master indexes or search online to find documentation of related commands.
priority-list protocol
group Number of the priority group. It can be a number in the range 1 to 10.