User guide

Installing the Cisco 2524 and Cisco 2525 Routers 3-3
Setting Up the Chassis
Setting Up the Chassis
You can set the chassis on a desktop, install it in a rack, or mount it on a wall or other flat
surface. Use the procedure in this section that best fits the needs of your network.
Setting the Chassis on a Desktop
Before setting the router on a desktop, shelf, or other flat, secure surface, perform the
following steps to install the rubber feet:
Step 1 Locate the rubber feet on the black adhesive strip that shipped with the chassis.
(See Figure 3-1.)
Figure 3-1 Identifying the Rubber Feet
Step 2
Place the router upside down on a smooth, flat surface.
Step 3 Peel off the rubber feet from the black adhesive strip and place them adhesive-side
down onto the five round, recessed areas on the bottom of the chassis, as shown in
Figure 3-2.
Rubber feet (5)
Black adhesive strip
H4796