User guide

Installing the Cisco 2524 and Cisco 2525 Routers 3-15
Connecting to the Network
You can connect the router to your Ethernet network in one of the following ways:
• Use an Ethernet AUI cable to connect the Ethernet AUI port to an Ethernet transceiver.
(See Figure 3-15.)
• Use a straight-through 10BaseT cable to connect the 10BaseT port to a 10BaseT hub.
(See Figure 3-16.)
• Use a crossover 10BaseT cable to connect the 10BaseT port to a PC network interface
card. (See Figure 3-17.)
Note If your Ethernet connection requires jackscrews, remove the slide-latch assembly
from the AUI connector and attach the jackscrews provided.
Figure 3-15 Connecting to an Ethernet Transceiver
SERIAL 1
SERIAL 0
BRI 0
H5368
Ethernet AUI port
DB-15 connector
(with jackscrews
or slide-latch)
Ethernet
AUI cable
(not supplied)
Router
Ethernet
transceiver
BNC connector
To thin
Ethernet
network
To thin
Ethernet
network