Specifications

B-10 Cisco Multiport Router Installation and Configuration Guide
Closing the Chassis
Step 9 Insert the new SIMM by sliding the end with the metal fingers into the
appropriate SIMM connector socket (labeled CODE0 or CODE1) at
approximately a 45-degree angle to the system card. Gently rock the SIMM back
into place until the latches on both sides snap into place. Do not use excessive
force because the connector may break.
Step 10 Replace the router cover following the procedure in the next section, “Closing
the Chassis.”
Closing the Chassis
This section describes the procedure for closing the chassis by replacing the cover.
Tools Required
You will need the following tools to replace the cover:
• Medium-size flat-blade screwdriver (1/4 inch [0.625 cm])
• Size M 3.5 hex-head nut driver (optional)
Replacing the Cover
Take the following steps to replace the cover:
Step 1 Position the two chassis sections, as shown in Figure B-5.
Step 2 Referring to Figure B-5, press the two chassis sections together and ensure the
following:
• The top section fits into the rear of the bottom section. (See A in Figure B-5.)
• The bottom section fits into the front of the top section. (See B in
Figure B-5.)
• Each side of the top and bottom sections fits together. (See C in Figure B-5.)