Specifications

4-12 Cisco Multiport Router Installation and Configuration Guide

Configuring the Router

Step 3 If IPX is enabled on this interface, enter the unique IPX network number:

Configure IPX on this interface? [no]: yes

IPX network number [1]: B001

Configure XNS on this interface? [no]

Conﬁguring the Synchronous Serial Interfaces

The synchronous serial interfaces are conﬁgured to allow connection to WANs through a

CSU/DSU. All serial ports on the multiport serial router are initially conﬁgured as

synchronous ports. When the initial conﬁguration is completed, conﬁgure the serial ports

you plan to use as asynchronous ports using the physical-layer command in conﬁguration

mode. Take the following steps to conﬁgure the serial port(s):

Step 1 Enter yes to conﬁgure serial port 0:

Configuring interface Serial0:

Is this interface in use? [no]: yes

Step 2 Determine what protocols you want on the synchronous serial interface and enter

the appropriate responses:

Configure IP unnumbered on this interface? [no]: no

IP address for this interface: 172.16.73.1

Number of bits in subnet field [8]:

Class B network is 172.16.0.0, 8 subnet bits; mask is 255.255.255.0

Configure AppleTalk on this interface? [no]: yes

Extended AppleTalk network? [yes]:

AppleTalk starting cable range [2]: 3

AppleTalk ending cable range [3]: yes

AppleTalk zone name [myzone]: ZZ Serial

AppleTalk additional zone name:

Configure IPX on this interface? [no]: yes

IPX network number [2]: B000