Specifications

Configuring the Router 4-11

Configuring the Router

In this example, routing is enabled on AppleTalk and IPX; IP has already been

selected:

Configure AppleTalk? [no]: yes

Multizone networks? [no]: yes

Configure LAT? [yes]: no

Configure IPX? [no]: yes

Conﬁguring the Ethernet or Token Ring Interfaces

Take the following steps to conﬁgure the Ethernet or Token Ring interface to allow

communication over a LAN. To conﬁgure the interface parameters, you need to know the

Ethernet or Token Ring interface network addresses. In the following example, the system

is being conﬁgured for an Ethernet LAN using IP.

Step 1 Respond as follows (using your own address and subnet bits) to the setup prompts:

Configuring interface Ethernet0:

Is this interface in use? [yes]:

Configure IP on this interface? [yes]:

IP address for this interface: 172.16.72.1

Number of bits in subnet field [0]: 8

Class B network is 172.16.0.0, 8 subnet bits; mask is 255.255.255.0

Step 2 Enter yes if you are using AppleTalk on the interface, enter yes to conﬁgure for

extended AppleTalk networks, and then enter the cable range number. Enter the

zone name, and any other additional zones that are associated with the local zone:

Configure AppleTalk on this interface? [no]: yes

Extended AppleTalk network? [no]: yes

AppleTalk starting cable range [0]: 1

AppleTalk ending cable range [1]: 2

AppleTalk zone name [myzone]:

AppleTalk additional zone name: otherzone

AppleTalk additional zone name: