Specifications

4-10 Cisco Multiport Router Installation and Configuration Guide

Configuring the Router

Conﬁguring the ISDN BRI Interface

This section explains how to conﬁgure the ISDN BRI interface. If an ISDN BRI WAN

module is not installed in your router, skip this section and proceed with the next section,

“Conﬁguring the Ethernet or Token Ring Interfaces.”

The ISDN BRI interface is conﬁgured to allow connection to ISDN WANs. Take the

following steps to conﬁgure the ISDN BRI interface:

Step 1 Press Return or enter yes to conﬁgure the ISDN BRI port:

Configuring interface BRI0:

Is this interface in use? [yes]

Configure IP on this interface? [yes]

IP address for this interface: 172.16.71.1

Number of bits in subnet field [0]: 8

lass B network is 172.16.0.0, 8 subnet bits; mask is

255.255.255.0

Configure AppleTalk on this interface? [no]: yes

Extended AppleTalk network? [no]: yes

AppleTalk starting cable range [0]: 1

AppleTalk ending cable range [1]: 2

AppleTalk zone name [myzone]:

AppleTalk additional zone name: otherzone

AppleTalk additional zone name:

Configure IPX on this interface? [no]: yes

IPX network number [1]: B000

North America

basic-5ess AT&T basic rate switches

basic-dms100 NT DMS-100 basic rate switches

basic-ni1 National ISDN-1 switches

Table 4-1 ISDN Switch Types (Continued)

Country: ISDN Switch Type Description