User guide

Installing the Cisco 2500 Series Access Server 3-7

Wall-Mounting the Chassis

Following is the procedure for wall-mounting the chassis:

Step 1 Attach the brackets as shown in Figure 3-7.

Figure 3-7 Attaching the Wall-Mount Brackets

Step 2

Using screws and anchors you provide, attach the chassis assembly to the wall as

shown in Figure 3-8. We recommend the following:

• For the best support of the chassis and cables, attach the brackets so that the

screws align with a vertical wall stud.

• For the best ventilation of the chassis, mount the chassis with the power supply

and fan at the top.

Caution To prevent the chassis from pulling away from the wall when cables are attached,

align the brackets and screws with a vertical wall stud. (See Figure 3-8.) To ensure adequate

ventilation, make sure there is clearance between the access server and the wall by adjusting

the brackets on the access server. Mount the access server as shown in Figure 3-8, placing

the chassis fan and power supply at the top.

H1714

Input: 100-240VAC

Freq: 50/60 Hz

Current: 1.2-0.6A

Watts: 40W