User guide

Installing the Cisco 2500 Series Access Server 3-3

Installing the Rubber Feet

This section explains how to install the rubber feet on the bottom of the chassis. If you want

to rack-mount the chassis, skip this section and proceed with the next section,

“Rack-Mounting the Chassis.” To wall-mount the chassis, skip this section and proceed

with the section “Wall-Mounting the Chassis” later in this chapter.

Before placing the access server on a desktop, shelf, or other ﬂat, secure surface, perform

the following steps to install the rubber feet:

Step 1 Locate the rubber feet on the black adhesive strip that shipped with the chassis.

(See Figure 3-1.)

Figure 3-1 Identifying the Rubber Feet

Step 2

Place the access server upside down on a smooth, ﬂat surface.

Step 3 Peel off one of the rubber feet from the black adhesive strip and place it

adhesive-side down onto one of the ﬁve round recessed areas on the back of the

chassis, as shown in Figure 3-2. Repeat this step to install the remaining four feet.

Rubber feet (5)

Black adhesive strip

H4796