User guide

Maintaining the Cisco 2500 Series Access Server B-11
Replacing System-Code SIMMs
Step 5 Locate the system-code SIMMs on the system card. The SIMM sockets are
labeled CODE 0 and CODE 1 (shown in Figure B-2).
Step 6 Remove the existing system-code SIMM by pulling outward on the connector
holders to unlatch them. The connector holds the SIMM tightly, so be careful not
to break the holders on the SIMM connector. (See Figure B-6.)
Caution To prevent damage, do not press on the center of the SIMMs. Handle each SIMM
carefully.
Step 7 Repeat these steps for all the system-code SIMMs to be replaced.
Figure B-6 Removing and Replacing the System-Code SIMM
Polarization notch
Flash memory SIMM card
H3559
Pull the tabs away with
your thumbs, bracing your
forefingers against the
posts. Raise the SIMM
to a vertical position.
Connector edge of
the system card