Specifications

4-99
Cisco Wireless LAN Controller Configuration Guide
OL-21524-02
Chapter 4 Configuring Controller Settings
Configuring the Cisco Discovery Protocol
Step 1 Choose Monitor > CDP > Interface Neighbors to open the CDP > Interface Neighbors page appears
(see Figure 4-42).
Figure 4-42 CDP > Interface Neighbors Page
This page shows the following information:
• The controller port on which the CDP packets were received
• The name of each CDP neighbor
• The IP address of each CDP neighbor
• The port used by each CDP neighbor for transmitting CDP packets
• The time left (in seconds) before each CDP neighbor entry expires
• The functional capability of each CDP neighbor, defined as follows: R - Router, T - Trans Bridge,
B - Source Route Bridge, S - Switch, H - Host, I - IGMP, r - Repeater, or M - Remotely Managed
Device
• The hardware platform of each CDP neighbor device
Step 2 Click the name of the desired interface neighbor to see more detailed information about each interface’s
CDP neighbor. The CDP > Interface Neighbors > Detail page appears (see Figure 4-43).