Specifications

4-98
Cisco Wireless LAN Controller Configuration Guide
OL-21524-02
Chapter 4 Configuring Controller Settings
Configuring the Cisco Discovery Protocol
Figure 4-41 All APs > Details for (Advanced) Page
d.
Select the Cisco Discovery Protocol check box to enable CDP on this access point or unselect
it to disable this feature. The default value is enabled.
Note If CDP is disabled in Step 2, a message indicating that the Controller CDP is disabled
appears.
• Enable CDP for a specific Ethernet interface, radio, or slot as follows:
a. Choose Wireless > Access Points > All APs to open the All APs page.
b. Click the link for the desired access point.
a. Choose the Interfaces tab and select the corresponding check boxes for the radios or slots from
the CDP Configuration section.
Note Configuration for radios is only applicable for mesh access points.
b. Click Apply to commit your changes.
• To enable or disable CDP on all access points currently associated to the controller, follow these
steps:
a. Choose Wireless > Access Points > Global Configuration to open the Global Configuration
page.
b. Select the CDP State check box to enable CDP on all access points associated to the controller
or unselect it to disable CDP on all access points. The default value is selected. You can enable
CDP on a specific Ethernet interface, radio, or slot by selecting the corresponding check box.
This configuration will be applied to all access points associated with the controller.
c. Click Apply to commit your changes.
Step 9 Click Save Configuration to save your changes.
Using the GUI to View Cisco Discovery Protocol Information
To view CDP information using the controller GUI, follow these steps: