Specifications

4-97
Cisco Wireless LAN Controller Configuration Guide
OL-21524-02
Chapter 4 Configuring Controller Settings
Configuring the Cisco Discovery Protocol
Figure 4-40 CDP > Global Configuration Page
Step 2
Select the CDP Protocol Status check box to enable CDP on the controller or unselect it to disable this
feature. The default value is selected.
Note Enabling or disabling this feature is applicable to all controller ports.
Step 3 From the CDP Advertisement Version drop-down list, choose v1 or v2 to specify the highest CDP
version supported on the controller. The default value is v1.
Step 4 In the Refresh-time Interval text box, enter the interval at which CDP messages are to be generated. The
range is 5 to 254 seconds, and the default value is 60 seconds.
Step 5 In the Holdtime text box, enter the amount of time to be advertised as the time-to-live value in generated
CDP packets. The range is 10 to 255 seconds, and the default value is 180 seconds.
Step 6 Click Apply to commit your changes.
Step 7 Click Save Configuration to save your changes.
Step 8 Perform one of the following:
• To enable or disable CDP on a specific access point, follow these steps:
a. Choose Wireless > Access Points > All APs to open the All APs page.
b. Click the link for the desired access point.
c. Choose the Advanced tab to open the All APs > Details for (Advanced) page (see Figure 4-41).