Specifications

4-9
Cisco Wireless LAN Controller Configuration Guide
OL-21524-02
Chapter 4 Configuring Controller Settings
Installing and Configuring Licenses
Note Typically, you are prompted to accept the EULA for evaluation, extension, and rehost licenses.
The EULA is also required for permanent licenses, but it is accepted during license generation.
Step 3 Add comments to a license or delete comments from a license by entering this command:
license comment {add | delete} license_name comment_string
Step 4 Save a backup copy of all installed licenses by entering this command:
license save url
where url is tftp://server_ip/path/filename.
Step 5 Reboot the controller by entering this command:
reset system
Step 6 Follow the instructions in the “Viewing Licenses” section on page 4-9 to see the status of the license you
installed.
Step 7 If the desired license is not being used by the controller, follow the instructions in the “Activating an
AP-Count Evaluation License” section on page 4-14 or the “Activating an AP-Count Evaluation
License” section on page 4-14 to change the license that is used by the controller.
Viewing Licenses
This section describes how to view the licenses on the controller.
Using the GUI to View Licenses
To view licenses on the controller using the controller GUI, follow these steps:
Step 1 Choose Management > Software Activation > Licenses to open the Licenses page (see Figure 4-4).