Specifications

4-83
Cisco Wireless LAN Controller Configuration Guide
OL-21524-02
Chapter 4 Configuring Controller Settings
Configuring Voice and Video Parameters
Figure 4-37 802.11a > Media Parameters Page
Step 5 Choose the Media tab to open the Media page.
Step 6 Select the Unicast Video Redirect check box to enable Unicast Video Redirect. The default value is
disabled.
Step 7 In the Maximum Media Bandwidth (0-85%) text box, enter the percentage of the maximum bandwidth
to be allocated for media applications on this radio band. Once the client reaches the specified value, the
access point rejects new calls on this radio band.
The default value is 85%; valid values are from 0 to 85%.
Step 8 In the Client Phy Rate text box, enter the value for the rate in kilobits per second at which the client
operates.
Step 9 In the Maximum Retry Percent (0-100%) text box, enter the percentage of the maximum retry. The
default value is 80.
Step 10 Select the Multicast Direct Enable check box to enable the Multicast Direct Enable text box. The
default value is enabled.
Step 11 From the Max Streams per Radio drop-down list, choose the maximum number of allowed multicast
direct streams per radio. Choose a value betweeen 1 to 20 or No Limit. The default value is set to No
Limit.
Step 12 From the Max Streams per Client drop-down list, choose the maximum number of allowed clients per
radio. Choose a value betweeen 1 to 20 or No Limit. The default value is set to No Limit.
Step 13 If you want to enable the best radio queue for this radio, select the Best Effort QoS Admission check
box. The default value is disabled.
Using the CLI to Configure SIP Based CAC
To configure the SIP based CAC using the controller CLI, follow these steps: