Specifications

4-77
Cisco Wireless LAN Controller Configuration Guide
OL-21524-02
Chapter 4 Configuring Controller Settings
Configuring Voice and Video Parameters
Step 17 Reenable all WMM WLANs and click Apply.
Step 18 Choose Network under 802.11a/n or 802.11b/g/n, select the 802.11a (or 802.11b/g) Network Status
check box, and click Apply to reenable the radio network.
Step 19 Click Save Configuration to save your changes.
Step 20 Repeat this procedure if you want to configure voice parameters for another radio band (802.11a or
802.11b/g).
Using the GUI to Configure Video Parameters
To configure video parameters using the controller GUI, follow these steps:
Step 1 Make sure that the WLAN is configured for WMM and the Gold QoS level.
Step 2 Disable all WLANs with WMM enabled and click Apply.
Step 3 Choose Wireless and then Network under 802.11a/n or 802.11b/g/n, unselect the 802.11a (or
802.11b/g) Network Status check box, and click Apply to disable the radio network.
Step 4 Choose Wireless > 802.11a/n or 802.11b/g/n > Media. The 802.11a (or 802.11b) > Media page appears
(see Figure 4-30).
Figure 4-30 802.11a > Video Parameters Page
Step 5 Choose the Video tab to configure the CAC for Video parameters.
Step 6 Select the Admission Control (ACM) check box to enable video CAC for this radio band. The default
value is disabled.
Step 7 In the Max RF Bandwidth text box, enter the percentage of the maximum bandwidth allocated to clients
for video applications on this radio band. Once the client reaches the value specified, the access point
rejects new requests on this radio band.
The range is 5 to 85%. The sum of maximum bandwidth% of voice and video should not exceed 85%.
The default is 0%.