Specifications

4-47
Cisco Wireless LAN Controller Configuration Guide
OL-21524-02
Chapter 4 Configuring Controller Settings
Configuring Aggressive Load Balancing
Step 4 Click Apply to commit your changes.
Step 5 Click Save Configuration to save your changes.
Step 6 To enable or disable aggressive load balancing on specific WLANs, choose WLANs > WLAN ID. The
WLANs > Edit page appears.
Step 7 Click the Advanced tab (see Figure 4-20).
Figure 4-20 WLANs > Advanced Page
Step 8 Click Apply to commit your changes.
Step 9 Click Save Configuration to save your settings
Using the CLI to Configure Aggressive Load Balancing
To configure aggressive load balancing using the controller CLI, follow these steps:
Step 1 Set the client window for aggressive load balancing by entering this command:
config load-balancing window client_count
You can enter a value between 0 and 20 for the client_count parameter.
Step 2 Set the denial count for load balancing by entering this command:
config load-balancing denial denial_count
You can enter a value between 1 and 10 for the denial_count parameter.
Step 3 Save your changes by entering this command:
save config
Step 4 Enable or disable aggressive load balancing on specific WLANs by entering this command:
config wlan load-balance allow {enable | disable} wlan_ID
You can enter a value between 1 and 512 for wlan_ID parameter.
Step 5 Verify your settings by entering this command: