Specifications

4-41
Cisco Wireless LAN Controller Configuration Guide
OL-21524-02
Chapter 4 Configuring Controller Settings
Changing the Default Values of SNMP Community Strings
Figure 4-15 SNMP v1 / v2c Community Page
Step 2
If “public” or “private” appears in the Community Name column, hover your cursor over the blue
drop-down arrow for the desired community and choose Remove to delete this community.
Step 3 Click New to create a new community. The SNMP v1 / v2c Community > New page appears (see
Figure 4-16).
Figure 4-16 SNMP v1 / v2c Community > New Page
Step 4 In the Community Name text box, enter a unique name containing up to 16 alphanumeric characters. Do
not enter “public” or “private.”
Step 5 In the next two text boxes, enter the IP address from which this device accepts SNMP packets with the
associated community and the IP mask.
Step 6 Choose Read Only or Read/Write from the Access Mode drop-down list to specify the access level for
this community.
Step 7 Choose Enable or Disable from the Status drop-down list to specify the status of this community.
Step 8 Click Apply to commit your changes.
Step 9 Click Save Configuration to save your settings.
Step 10 Repeat this procedure if a “public” or “private” community still appears on the SNMP v1 / v2c
Community page.
Using the CLI to Change the SNMP Community String Default Values
To change the SNMP community string default values using the controller CLI, follow these steps: