Specifications

4-118
Cisco Wireless LAN Controller Configuration Guide
OL-21524-02
Chapter 4 Configuring Controller Settings
Configuring the Supervisor 720 to Support the WiSM
RSSI Mobile Station, Tags,
Info Mobile Station,
Statistics Mobile Station, Tags,
• Clear all NMSP statistics by entering this command:
clear nmsp statistics
Debugging NMSP Issues
Use these CLI commands if you experience any problems with NMSP:
• Configure NMSP debug options by entering this command:
debug nmsp ?
where ? is one of the following:
– all {enable | disable}—Enables or disables debugging for all NMSP messages.
– connection {enable | disable}—Enables or disables debugging for NMSP connection events.
– detail {enable | disable}—Enables or disables debugging for NMSP detailed events.
– error {enable | disable}—Enables or disables debugging for NMSP error messages.
– event {enable | disable}—Enables or disables debugging for NMSP events.
– message {tx | rx} {enable | disable}—Enables or disables debugging for NMSP transmit or
receive messages.
– packet {enable | disable}—Enables or disables debugging for NMSP packet events.
• Enable or disable debugging for NMSP interface events by entering this command:
debug dot11 nmsp {enable | disable}
• Enable or disable debugging for IAPP NMSP events by entering this command:
debug iapp nmsp {enable | disable}
• Enable or disable debugging for RFID NMSP messages by entering this command:
debug rfid nmsp {enable | disable}
• Enable or disable debugging for access point monitor NMSP events by entering this command:
debug service ap-monitor nmsp {enable | disable}
• Enable or disable debugging for wIPS NMSP events by entering this command:
debug wips nmsp {enable | disable}
Configuring the Supervisor 720 to Support the WiSM
When you install a WiSM in a Cisco Catalyst 6500 series switch or a Cisco 7600 series router, you must
configure the Supervisor 720 to support the WiSM. When the supervisor detects the WiSM, the
supervisor creates ten Gigabit Ethernet interfaces, ranging from Gigslot/1 to Gigslot/8. For example, if
the WiSM is in slot 9, the supervisor creates interfaces Gig9/1 through Gig9/8. The first eight Gigabit
Ethernet interfaces must be organized into two EtherChannel bundles of four interfaces each. The
remaining two Gigabit Ethernet interfaces are used as service-port interfaces, one for each controller on
the WiSM. You must manually create VLANs to communicate with the ports on the WiSM.