Specifications

Installation and Startup 2-33
Connecting to the Switched AUI Port
Figure 2-16 Connecting to the AUI Port
Step 4
Connect the other end of the cable to the 10BaseT port of the network device.
Step 5 Check the LED on the AUI transceiver, or use the Port Management Page or the
Port Configuration Menu (10BaseT Ports) to check the AUI port status.
If the port LED is not on, or if the port status is not “Enabled,” look for the
following problems:
• The network device is not on.
• The Ethernet adapter in the network device is not operating correctly.
• The cable or transceiver is damaged or is not connected correctly.
• You are using the wrong type of cable.
If you are connecting the switch 10-Mbps port to an end-station, which is
configured for 100-Mbps, you need to reconfigure the end-station to operate at
10-Mbps.
Connector and cabling specifications for the AUI port are in Appendix B, “Connectors and
Cables.”
26636
Ethernet cable
(not supplied)
Ethernet AUI transceiver
(not supplied)
AUI slide latch
bracket
CONSOLE
DC INPUT
FOR REMOTE
POWER SUPPLY
SPECIFIED
IN MANUAL.
+5V @6A
+12V @1A
RATING
100-127V~
@0.6A
200-240V~
@0.3A
50-60Hz