Specifications

Installation and Startup 2-31

Connecting to the Switched 100-Mbps Fiber-Optic Ports

Step 3 Connect the other end of the cable to the SC or ST port of the network device.

Step 4 Make sure that the LED for the port that you connected in Step 1 turns on.

If the port LED is not on, look for the following problems:

• The network device is not on.

• The Ethernet adapter in the network device is not operating correctly.

• The cable is damaged or is not connected correctly.

• You are using the wrong type of cable.

If you are connecting the switch 100-Mbps port to an end-station, which is

conﬁgured for 10-Mbps, you need to reconﬁgure the end-station to operate at

100-Mbps.

Step 5 Repeat Steps 1 through 4 for each device that you are connecting to the switch.

Connector and cabling speciﬁcations for the 100-Mbps ﬁber-optic ports are in Appendix B,

“Connectors and Cables.”