Specifications

Connecting to the Switched 10BaseT Ports

Catalyst 1900 Series Installation and Configuration Guide

2-24

Figure 2-12 Connecting to a 10BaseT Port

Step 2

Connect the other end of the cable to the 10BaseT port of the network device.

Step 3 Make sure that the LED for the port that you connected in Step 1 turns on.

If the port LED is not on, look for the following problems:

• The network device is not on.

• The Ethernet adapter in the network device is not operating correctly.

• The cable is damaged or is not connected correctly.

• You are using the wrong type of cable.

If you are connecting the switch 10-Mbps port to an end-station, which is

conﬁgured for 100-Mbps, you need to reconﬁgure the end-station to operate at

10-Mbps.

Step 4 Repeat Steps 1 through 3 for each device that you are connecting to the switch.

Connector and cabling speciﬁcations for the 10BaseT ports are in Appendix B,

“Connectors and Cables.”

26638

Category 3, 4, or 5 cable

(not supplied)

RPS

MODE

1x 2x 3x 4x 5x 6x 7x 8x 9x 10x 11x 12x 13x 14x 15x 16x 17x 18x 19x 20x 21x 22x 23x 24x

SERIES

Ax Bx