Specifications

© Copyright 2007 Cisco Systems, Inc.
This document may be freely reproduced and distributed whole and intact including this Copyright Notice.
9
two link LEDs, two PVDM LEDs, two AIM LEDs, system status LED (SYS OK), system
activity (SYS ACT) LED, inline power LED, and CF LED. The back panel has the power inlet
and on/off switch.
The front panel contains the following:
• (1) VIC slot
• (2) HWIC/WIC/VIC slot 0
• (3) WIC/VIC slot
• (4) HWIC/WIC/VIC slot 1
• (5) Console port
• (6) FE ports
• (7) System status and activity LEDs
• (8) Inline power LED
• (9) USB port
• (10) FE LEDs
• (11) Auxiliary port
• (12) CF LED
• (13) CF drive
The rear panel contains the following:
• (1) Power inlet
• (2) Power switch
• (3) Ground connector
The following tables provide more detailed information conveyed by the LEDs on the front and
rear panel of the router:
Name State Description
System OK Solid Green
Blinking Green
Router has successfully booted up and the
software is functional.
Booting or in ROM monitor (ROMMON) mode.
Inline Power Solid Green
Amber
Off
Inline power supply is working properly.
Inline power failure.
Inline power supply is not present.
System Activity Solid Green
Blinking Green
Off
System is actively transferring packets.
System is servicing interrupts.
No interrupts or packet transfer occurring.
Compact Flash Solid Green
Off
Indicates that the flash is busy and should not be
removed.
OK to remove flash card.
PVDM1 Solid Green
Solid Orange
Off
PVDM1 installed and initialized.
PVDM1 installed and initialized error.
PVDM1 not installed.
PVDM0 Solid Green
Solid Orange
Off
PVDM0 installed and initialized.
PVDM0 installed and initialized error.
PVDM0 not installed.
AIM1 Solid Green
Solid Orange
AIM1 installed and initialized.
AIM1 installed and initialized error.