Specifications

This document may be freely reproduced and distributed whole and intact including this Copyright Notice.

Figure 3 – Cisco 2801 router case

The 2801 router is a multiple-chip standalone cryptographic module. The router has a processing

speed of 240MHz. Depending on configuration, either the installed AIM-VPN/BPII-Plus module

or the internal Giove FPGA or the IOS software is used for cryptographic operations.

The cryptographic boundary of the module is the device’s case, shown in Figure 3. All of the

functionality discussed in this document is provided by components within this cryptographic

boundary.

The interfaces for the router are located on the front and rear panel as shown in Figure 4 and

Figure 5, respectively.

Figure 4 – 2801 Front Panel Physical Interfaces

Figure 5 – 2801 Rear Panel Physical Interfaces

The Cisco 2801 router features a console port, an auxiliary port, Universal Serial Bus (USB)

port, two high-speed WAN interface card (HWIC) slots, Voice interface card (VIC) slot,

WIC/VIC slot, two10/100 Fast Ethernet RJ45 ports, and a Compact Flash (CF) drive. The 2801

router has two slots for AIM-VPN/BPII-Plus cards

, two internal packet voice data modules

(PVDMs), and two fast Ethernet connections. Figure 4 and Figure 5 show the front and read

panels of the router. The front panel consists of 14 LEDs: two duplex LEDs, two speed LEDs,

The security policy covers the configuration in which one AIM card is used.