Specifications

This document may be freely reproduced and distributed whole and intact including this Copyright Notice.

Figure 11 – Cisco 1841 Tamper Evident Label Placement (Back View)

Figure 12 – Cisco 1841 Tamper Evident Label Placement (Front View)

For Cisco 2801 router:

1. Clean the cover of any grease, dirt, or oil before applying the tamper evidence

labels. Alcohol-based cleaning pads are recommended for this purpose. The

temperature of the router should be above 10°C.

2. The tamper evidence label should be placed so that one half of the label covers

the front panel and the other half covers the enclosure.

3. The tamper evidence label should be placed over the CF card in the slot so that

any attempt to remove the card will show sign of tampering.

4. The tamper evidence label should be placed so that the one half of the label

covers the enclosure and the other half covers the port adapter slot.

5. Place tamper evident labels on the opacity shield as shown in Figures 9 and 10.

6. The labels completely cure within five minutes.

Figures 13 and 14 show the additional tamper evidence label placements for the 2801.