Specifications
Table Of Contents
- Contents
- Preface
- Getting Started
- Basic Router Configuration
- Interface Port Labels
- Viewing the Default Configuration
- Information Needed for Configuration
- Configuring Basic Parameters
- Configuring Static Routes
- Configuring Dynamic Routes
- Configuring Enhanced IGRP
- Basic Router Configuration
- Configuring Your Router for Ethernet and DSL Access
- Sample Network Deployments
- Configuring PPP over Ethernet with NAT
- Configuring PPP over ATM with NAT
- Configuring a LAN with DHCP and VLANs
- Configuring a VPN Using Easy VPN and an IPSec Tunnel
- Configure the IKE Policy
- Configure Group Policy Information
- Apply Mode Configuration to the Crypto Map
- Enable Policy Lookup
- Configure IPSec Transforms and Protocols
- Configure the IPSec Crypto Method and Parameters
- Apply the Crypto Map to the Physical Interface
- Create an Easy VPN Remote Configuration
- Verifying Your Easy VPN Configuration
- Configuration Example
- Configuring VPNs Using an IPSec Tunnel and Generic Routing Encapsulation
- Configuring a Simple Firewall
- Configuring a Wireless LAN Connection
- Sample Configuration
- Configuring Additional Features and Troubleshooting
- Additional Configuration Options
- Configuring Security Features
- Configuring Dial Backup and Remote Management
- Troubleshooting
- Reference Information
- Cisco IOS Software Basic Skills
- Concepts
- ROM Monitor
- Common Port Assignments
3-10
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
OL-6426-02
Chapter 3 Configuring PPP over Ethernet with NAT
Configuration Example
Verifying Your Configuration
Use the show ip nat statistics command in privileged EXEC mode to verify NAT configuration. You
should see verification output similar to the following example:
Router# show ip nat statistics
Total active translations: 0 (0 static, 0 dynamic; 0 extended)
Outside interfaces:
FastEthernet4
Inside interfaces:
Vlan1
Hits: 0 Misses: 0
CEF Translated packets: 0, CEF Punted packets: 0
Expired translations: 0
Dynamic mappings:
-- Inside Source
[Id: 1] access-list 1 interface Dialer0 refcount 0
Queued Packets: 0