Specifications
Table Of Contents
- Contents
- Preface
- Getting Started
- Basic Router Configuration
- Interface Port Labels
- Viewing the Default Configuration
- Information Needed for Configuration
- Configuring Basic Parameters
- Configuring Static Routes
- Configuring Dynamic Routes
- Configuring Enhanced IGRP
- Basic Router Configuration
- Configuring Your Router for Ethernet and DSL Access
- Sample Network Deployments
- Configuring PPP over Ethernet with NAT
- Configuring PPP over ATM with NAT
- Configuring a LAN with DHCP and VLANs
- Configuring a VPN Using Easy VPN and an IPSec Tunnel
- Configure the IKE Policy
- Configure Group Policy Information
- Apply Mode Configuration to the Crypto Map
- Enable Policy Lookup
- Configure IPSec Transforms and Protocols
- Configure the IPSec Crypto Method and Parameters
- Apply the Crypto Map to the Physical Interface
- Create an Easy VPN Remote Configuration
- Verifying Your Easy VPN Configuration
- Configuration Example
- Configuring VPNs Using an IPSec Tunnel and Generic Routing Encapsulation
- Configuring a Simple Firewall
- Configuring a Wireless LAN Connection
- Sample Configuration
- Configuring Additional Features and Troubleshooting
- Additional Configuration Options
- Configuring Security Features
- Configuring Dial Backup and Remote Management
- Troubleshooting
- Reference Information
- Cisco IOS Software Basic Skills
- Concepts
- ROM Monitor
- Common Port Assignments
Contents
4
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration GuideCisco 1800 Series Integrated Services Routers (Fixed)
OL-6426-02
Configuring a Loopback Interface 9
Configuration Example 9
Verifying Your Configuration 10
Configuring Command-Line Access to the Router 10
Configuration Example 12
Configuring Static Routes 12
Configuration Example 13
Verifying Your Configuration 13
Configuring Dynamic Routes 13
Configuring RIP 14
Configuration Example 15
Verifying Your Configuration 15
Configuring Enhanced IGRP 15
Configuration Example 16
Verifying Your Configuration 16
PART
2 Configuring Your Router for Ethernet and DSL Access
CHAPTER
2 Sample Network Deployments 1
CHAPTER
3 Configuring PPP over Ethernet with NAT 1
Configure the Virtual Private Dialup Network Group Number 2
Configure the Fast Ethernet WAN Interfaces 3
Configure the Dialer Interface 5
Configure Network Address Translation 7
Configuration Example 9
Verifying Your Configuration 10
CHAPTER
4 Configuring PPP over ATM with NAT 1
Configure the Dialer Interface 3
Configure the ATM WAN Interface 5
Configure DSL Signaling Protocol 6
Configuring ADSL 6
Verify the Configuration 7
Configuring SHDSL 7
Verify the Configuration 8
Configure Network Address Translation 9
Configuration Example 11