Specifications

1-8
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
OL-6426-02
Chapter 1 Basic Router Configuration
Configuring Basic Parameters
Configure the ATM WAN Interface
This procedure applies only to the Cisco 1801, Cisco 1802, and Cisco 1803 models.
Perform these steps to configure the ATM interface, beginning in global configuration mode:
Command Purpose
Step 1
For the Cisco 1803 only:
controller dsl 0
mode atm
exit
Example:
Router(config)# controller dsl 0
Router(config-controller)# mode atm
Router(config-controller)# exit
Router(config)#
For routers using the G.SHDSL signaling, perform
these commands. Ignore this step for routers using
ADSL signaling.
Step 2
interface type number
Example:
Router(config)# interface atm0
Router(config-int)#
Enters interface configuration mode.
Step 3
ip address ip-address mask
Example:
Router(config-int)# ip address
200.200.100.1 255.255.255.0
Router(config-int)#
Sets the IP address and subnet mask for the ATM
interface.
Step 4
no shutdown
Example:
Router(config-int)# no shutdown
Router(config-int)#
Enables the ATM 0 interface.
Step 5
exit
Example:
Router(config-int)# exit
Router(config)#
Exits interface configuration mode and returns to
global configuration mode.