Specifications

xxxvii
Cisco 1751 Router Software Configuration Guide
OL-1070-01
Related Commands
show call history voice
show dial-peer voice
show num-exp
show voice port
show call history voice
To display the call history table, use the show call history voice privileged EXEC command.
show call history voice last number
Syntax Description
Command Mode
Privileged EXEC.
RemoteIPAddress Remote system IP address for the VoIP call.
RemoteUDPPort Remote system UDP listener port to which voice packets are
transmitted.
RoundTripDelay Voice packet round trip delay between the local and remote system on
the IP backbone during the call.
SelectedQoS Selected RSVP QoS for the call.
SessionProtocol Session protocol used for an Internet call between the local and
remote router via the IP backbone.
SessionTarget Session target of the peer used for the call.
SetupTime Value of the System UpTime when the call associated with this entry
was started.
TransmitBytes Number of bytes transmitted from this peer during the call.
TransmitPackets Number of packets transmitted from this peer during the call.
TxDuration Duration of transmit path open from this peer to the voice gateway for
the call.
VADEnable Whether or not VAD was enabled for this call.
VoiceTxDuration Duration of voice transmission from this peer to voice gateway for this
call. You can derive the Voice Utilization Rate by dividing the
VoiceTxDuration value by the TxDuration value.
Table 3 Show-Call-Active-Voice Command Field Descriptions (Continued)
Field Description
last number Displays the last calls connected, where the number of calls displayed
is defined by the argument number. Valid entries for the argument
number is any number from 1 to 2147483647.