Specifications

xxxii
Cisco 1751 Router Software Configuration Guide
OL-1070-01
Related Commands
ring frequency
session protocol
To establish a session protocol for calls between the local and remote routers via the packet network,
use the session protocol dial-peer configuration command. Use the no form of this command to reset
the default value for this command.
session protocol cisco
no session protocol
Syntax Description
Default
cisco.
Command Mode
Dial-peer configuration.
Usage Guidelines
For this release, cisco is the only applicable session protocol. This command only applies to VoIP peers.
Example
The following example selects Cisco Session Protocol as the session protocol:
dial-peer voice 10 voip
session protocol cisco
Related Commands
session target
session target
To specify a network-specific address for a specified dial peer, use the session target dial-peer
configuration command. Use the no form of this command to disable this feature.
session target {ipv4:destination-address | dns:[$s$. | $d$. | $u$.] host-name | loopback:rtp |
loopback:compressed | loopback:uncompressed}
no session target
cisco Cisco Session Protocol.