Specifications

vi
Cisco 1751 Router Software Configuration Guide
OL-1070-01
For calls coming in from a POTS interface, the answer-address command is not used to select an
incoming dial peer. The incoming POTS dial peer is selected on the basis of the port configured for that
dial peer.
This command applies to both VoIP and POTS dial peers.
Note The Cisco IOS software does not check the validity of the E.164 telephone number; it
accepts any series of digits as a valid number.
Example
The following example configures the E.164 telephone number, 14085559626, as the dial peer of an
incoming call:
dial-peer voice 10 pots
answer-address 14085559626
Related Commands
destination-pattern
port
prefix
codec
To specify the voice coder rate of speech for a dial peer, use the codec dial-peer configuration command.
Use the no form of this command to reset the default value for this command.
codec {g711alaw | g711ulaw | g723ar53 | g723ar63 | g723r53 | g723r63 | g726r16 | g726r24 |
g726r32 | g729br8 | g729r8}
no codec