Specifications

xxi
Cisco 1751 Router Software Configuration Guide
OL-1070-01
Note After you change any voice-port command, we recommend that you cycle the port by
using the shutdown and no shutdown commands.
Additional VoIP Dial Peer Configurations
Depending on how you have configured your network interfaces, you might need to configure additional
VoIP dial-peer parameters This section describes the following topics:
• Configure IP Precedence for Dial Peers
• Configure RSVP for Dial Peers
• Configure CODEC and VAD for Dial Peers
Step 7
non-linear Enable nonlinear processing,
which shuts off any signal if
no near-end speech is
detected. (Nonlinear
processing is used with
echo-cancellation.)
Step 8
timeouts initial seconds Specify the number of
seconds the system will wait
for the caller to input the first
digit of the dialed digits.
0to120 sec 10 sec
Step 9
timeouts interdigit seconds Specify the number of
seconds the system will wait
(after the caller has input the
initial digit) for the caller to
input a subsequent digit.
0 to 120 sec 10 sec
Step 10
timing clear-wait milliseconds
timing delay-duration
milliseconds
timing delay-start milliseconds
timing dial-pulse min-delay
milliseconds
timing digit milliseconds
timing inter-digit milliseconds
timing pulse pulses-per-second
timing
pulse-inter-digit milliseconds
timing wink-duration
milliseconds
timing wink-wait milliseconds
Specify timing parameters for
each of these commands.
200 to 2000 ms
100 to 5000 ms
20 to 2000 ms
0 to 5000 ms
50 to 100 ms
50 to 500 ms
10 to 20 pps
100 to 1000 ms
100 to 400 ms
100 to 5000 ms
Command Task Valid Entries
Default
Values