Specifications

iv
Cisco 1751 Router Software Configuration Guide
OL-1070-01
Configuring IPX Routing over IEEE 802.1Q
IPX Routing over IEEE 802.1Q VLANs extends Novell NetWare routing capabilities to include support
for routing Novell Ethernet_802.3 encapsulation frame types in VLAN configurations. Users with
Novell NetWare environments can configure Novell Ethernet_802.3 encapsulation frames to be routed
using IEEE 802.1Q encapsulation across VLAN boundaries.
To configure Cisco IOS software on a router with connected VLANs to exchange IPX Novell
Ethernet_802.3 encapsulated frames, perform these tasks in the order in which they are appear:
• Enabling NetWare Routing
• Defining the VLAN Encapsulation Format
• Configuring NetWare on the Subinterface
Enabling NetWare Routing
To enable IPX routing on IEEE 802.1Q interfaces, use the following command in global configuration
mode:
Defining the VLAN Encapsulation Format
To define the encapsulation format as IEEE 802.1Q, use the following commands in interface
configuration mode:
Configuring NetWare on the Subinterface
After you enable NetWare globally and define the VLAN encapsulation format, you may need to enable
the subinterface by specifying the NetWare network number. Use this command in interface
configuration mode:
Command Purpose
ipx routing [node]
Enables IPX routing globally.
Command Purpose
Step1
interface fastethernet
slot/port.subinterface-number
Specifies the subinterface on which IEEE 802.1Q will
be used.
Step2
encapsulation dot1q vlan-identifier
Defines the encapsulation format as IEEE 802.1Q and
specify the VLAN identifier.
Command Purpose
ipx network network
Specifies the IPX network number.