Specifications

v
Cisco 1751 Router Software Configuration Guide
OL-1070-01
The following output shows that disconnection is generated from the calling party and that call legs are
torn down and disconnected:
cc_api_call_disconnected(vdbPtr=0x60BFB530, callID=0x1, cause=0x10)
sess_appl: ev(9), cid(1), disp(0)
ssa: cid(1)st(5)oldst(3)cfid(1)csize(0)in(1)fDest(0)-cid2(2)st2(5)oldst2(4)
ccConferenceDestroy (confID=0x1, tag=0x0)
cc_api_bridge_done (confID=0x1, srcIF=0x60B6C5D4, srcCallID=0x2, dstCallID=0x1,
disposition=0 tag=0x0)
cc_api_bridge_done (confID=0x1, srcIF=0x60BFB530, srcCallID=0x1, dstCallID=0x2,
disposition=0 tag=0x0)
sess_appl: ev(18), cid(1), disp(0)
ssa: cid(1)st(6)oldst(5)cfid(-1)csize(0)in(1)fDest(0)-cid2(2)st2(6)oldst2(4)
ccCallDisconnect (callID=0x1, cause=0x10 tag=0x0)
ccCallDisconnect (callID=0x2, cause=0x10 tag=0x0)
cc_api_call_disconnect_done(vdbPtr=0x60B6C5D4, callID=0x2, disp=0, tag=0x0)
sess_appl: ev(10), cid(2), disp(0)
ssa: cid(2)st(7)oldst(4)cfid(-1)csize(0)in(0)fDest(0)-cid2(1)st2(7)oldst2(6)
cc_api_call_disconnect_done(vdbPtr=0x60BFB530, callID=0x1, disp=0, tag=0x0)
sess_appl: ev(10), cid(1), disp(0)
ssa: cid(1)st(7)oldst(6)cfid(-1)csize(1)in(1)fDest(0)
debug vpm all
Use the debug vpm all EXEC command to enable debugging on all virtual voice-port module (VPM)
areas. Use the no form of this command to disable debugging output.
[no] debug vpm all
Usage Guidelines
The debug vpm all EXEC command enables all of the debug vpm commands: debug vpm spi, debug
vpm signal, and debug vpm dsp. For more information or sample output, refer to the individual
commands in this chapter.
debug vpm dsp
Use the debug vpm dsp EXEC command to show messages from the digital signal processor (DSP) on
the virtual voice-port module (VPM) to the router. Use the no form of this command to disable
debugging output.
[no] debug vpm dsp
Usage Guidelines
The debug vpm dsp command shows messages from the DSP on the VPM to the router; this command
can be useful if you suspect that the VPM is not functional. It is a simple way to check if the VPM is
responding to off-hook indications and to evaluate timing for signaling messages from the interface.