Specifications

lxiv
Cisco 1751 Router Software Configuration Guide
OL-1070-01
Default
The default values for the timing keywords/arguments are listed in Table 10.
Command Mode
Voice-port configuration.
Usage Guidelines
Use the timing command to specify timing parameters other than those defined by the timeouts
commands.
Use the timing command with the dial-pulse min-delay keyword with PBXs requiring a wink-like
pulse, even though they have been configured for delay-dial signaling. If the value for this keyword is
set to 0, the router does not generate this wink-like pulse.
Table 11 lists the call signal directions for the timing keyword/argument pairs.
wink-duration milliseconds The maximum wink signal duration, in
milliseconds, for a wink start signal
Numbers from 100 to 400
wink-wait milliseconds The maximum wink-wait duration, in
milliseconds, for a wink start signal
Numbers from 100 to
5000
Table 9 Timing Keywords/Arguments, Descriptions, and Valid Entries
Table 10 Timing Keywords/Arguments Default Values
Keyword/Argument Default Value
clear-wait milliseconds 400 ms
delay-duration milliseconds 2000 ms
delay-start milliseconds 300 ms
dial-pulse min-delay milliseconds 140 ms
digit milliseconds 100 ms
inter-digit milliseconds 100 ms
pulse pulses per second 20 pps
pulse-inter-digit milliseconds 500 ms
wink-duration milliseconds 200 ms
wink-wait milliseconds 200 ms
Table 11 Timing Keywords/Arguments Call Signal Directions
Timing Keyword/Argument Call Signal Direction
clear-wait milliseconds Not applicable
delay-duration milliseconds Out
delay-start milliseconds Out