Specifications

lxiii
Cisco 1751 Router Software Configuration Guide
OL-1070-01
Related Commands
timeouts initial
timing
timing
To specify timing parameters (other than those defined by the timeouts commands) for a specified voice
port, use the timing voice-port configuration command. Use the no form of this command to reset the
default value for this command.
timing timing-value
no timing timing-value
Syntax Description
timing-value One of the keyword/argument pairs listed in Table 9.
Table 9 Timing Keywords/Arguments, Descriptions, and Valid Entries
Keyword/Argument Argument Description Valid Entries
clear-wait milliseconds The minimum amount of time, in
milliseconds, between the inactive
seizure signal and the call being cleared
Numbers from 200 to
2000
delay-duration milliseconds The delay signal duration for delay dial
signaling, in milliseconds
Numbers from 100 to
5000
delay-start milliseconds The minimum delay time, in
milliseconds, from outgoing seizure to
outdial address
Numbers from 20 to 2000
dial-pulse min-delay
milliseconds
The time, in milliseconds, between the
generation of wink-like pulses
Numbers from 0 to 5000
digit milliseconds The DTMF digit signal duration, in
milliseconds
Numbers from 50 to 100
inter-digit milliseconds The DTMF inter-digit duration, in
milliseconds
Numbers from 50 to 500
pulse pulses per second The pulse dialing rate, in pulses per
second
Numbers from 10 to 20
pulse-inter-digit milliseconds The pulse dialing inter-digit timing, in
milliseconds
Numbers from 100 to
1000