Specifications

lxii
Cisco 1751 Router Software Configuration Guide
OL-1070-01
Example
The following example sets the initial digit timeout value to 15 seconds:
voice port 0/0
timeouts initial 15
Related Commands
timeouts interdigit
timing
timeouts interdigit
To configure the interdigit timeout value for a specified voice port, use the timeouts interdigit
voice-port configuration command. Use the no form of this command to restore the default value for
this command.
timeouts interdigit seconds
no timeouts interdigit seconds
Syntax Description
Default
10 seconds.
Command Mode
Voice-port configuration.
Usage Guidelines
Use the timeouts interdigit command to specify the number of seconds the system waits (after the
caller has entered the initial digit) for the caller to enter a subsequent digit of the dialed digits. The
timeouts interdigit timer is activated when the caller enters a digit and is restarted each time the caller
enters another digit until the destination address is identified. If the configured timeout value is
exceeded before the destination address is identified, the caller is notified through the appropriate tone,
and the call is terminated.
To disable the timeouts interdigit timer, set the seconds value to 0.
Example
The following example sets the interdigit timeout value to 15 seconds:
voice port 0/0
timeouts interdigit 15
seconds Interdigit timeout duration in seconds. Valid entries are any integer
from 0 to 120.