Specifications

lxi
Cisco 1751 Router Software Configuration Guide
OL-1070-01
If you are managing the equipment with an SNMP manager (such as Maestro), enable this command.
Enabling link-status messages allows the SNMP manager to learn of a status change without polling
the equipment. If you are not using an SNMP manager, disable this command to avoid unnecessary
network traffic.
Example
The following example enables SNMP trap messages for voice port 1/0:
voice port 1/0
snmp trap link-status
Related Commands
snmp enable peer-trap poor-qov
snmp-server enable traps poor-qov
timeouts initial
To configure the initial digit timeout value for a specified voice port, use the timeouts initial voice-port
configuration command. Use the no form of this command to restore the default value for this
command.
timeouts initial seconds
no timeouts initial seconds
Syntax Description
Default
10 seconds.
Command Mode
Voice-port configuration.
Usage Guidelines
Use the timeouts initial command to specify the number of seconds the system waits for the caller to
enter the first digit of the dialed digits. The timeouts initial timer is activated when the call is accepted
and is deactivated when the caller enters the first digit. If the configured timeout value is exceeded, the
caller is notified through the appropriate tone, and the call is terminated.
To disable the timeouts initial timer, set the seconds value to 0.
seconds Initial timeout duration in seconds. Valid entries are any integer
from 0 to 120.