Specifications

lvi
Cisco 1751 Router Software Configuration Guide
OL-1070-01
shutdown (voice-port configuration)
To take the voice ports for a specific VIC offline, use the shutdown voice-port configuration command.
Use the no form of this command to put the ports back in service.
shutdown
no shutdown
Syntax Description
This command has no arguments or keywords.
Default
Enabled.
Command Mode
Voice-port configuration.
Usage Guidelines
When you enter the shutdown command, all ports on the VIC are disabled, and there is dead silence on
the telephone connected to the interface. When you enter the no shutdown command, all ports on the
VIC are enabled.
Example
The following example takes voice port 1/0 offline:
configure terminal
voice port 1/0
shutdown
Note The preceding configuration example first shuts down voice port 1/0 and then voice port
1/1.
signal
To specify the type of signaling for a voice port, use the signal voice-port configuration command. Use
the no form of this command to restore the default value for this command.
signal {loop-start | ground-start | wink-start | immediate | delay-dial}
no signal