Specifications

xlvi
Cisco 1751 Router Software Configuration Guide
OL-1070-01
The following is sample output from the show dial-peer voice command for a VoIP dial peer:
router# show dial-peer voice 10
VoiceOverIpPeer10
tag = 10, dest-pat = `',
incall-number = `14085',
group = 0, Admin state is up, Operation state is down
Permission is Answer,
type = voip, session target = `',
sess-proto = cisco, req-qos = bestEffort,
acc-qos = bestEffort,
fax-rate = voice, codec = g729r8,
Expect factor = 10,Icpif = 30, VAD = disabled, Poor QOV Trap = disabled,
Connect Time = 0, Charged Units = 0
Successful Calls = 0, Failed Calls = 0
Accepted Calls = 0, Refused Calls = 0
Last Disconnect Cause is “”
Last Disconnect Text is “”
Last Setup Time = 0
Table 5 explains the fields contained in both of these examples.
Table 5 Show-Dial-Peer-Voice Command Field Descriptions
Field Description
AcceptedCalls Number of calls from this peer accepted since system startup.
acc-qos Lowest acceptable QoS configured for calls for this peer.
Admin state Administrative state of this peer.
Charged Units Total number of charging units applying to this peer since system startup.
codec Default voice coder rate of speech for this peer.
Connect Time Accumulated connect time to the peer since system startup for both
incoming and outgoing calls.
dest-pat Destination pattern (telephone number) for this peer.
Expect factor User-requested Expectation Factor of voice quality for calls via this peer.
fax-rate Fax transmission rate configured for this peer.
Failed Calls Number of failed call attempts to this peer since system startup.
group Group number associated with this peer.
ICPIF Configured ICPIF value for calls sent by a dial peer.
incall-number Full E.164 telephone number to be used to identify the dial peer.
Last Disconnect Cause Encoded network cause associated with the last call. This value is updated
whenever a call is started or cleared and depends on the interface type and
session protocol being used on this interface.
Last Disconnect Text ASCII text describing the reason for the last call termination.
Last Setup Time Value of the System Up Time when the last call to this peer was started.
Operation state Operational state of this peer.
Permission Configured permission level for this peer.
Poor QOV Trap Whether poor-quality-of-voice trap messages have been enabled or
disabled.
Refused Calls Number of calls from this peer refused since system startup.