Datasheet

Lab – Configuring Frame Relay and Subinterfaces
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 8 of 38
Local 1 0 0 0
Switched 0 0 0 0
Unused 0 0 0 0
DLCI = 103, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE = Serial0/0/0
input pkts 22 output pkts 154 in bytes 2240
out bytes 10860 dropped pkts 0 in pkts dropped 0
out pkts dropped 0 out bytes dropped 0
in FECN pkts 0 in BECN pkts 0 out FECN pkts 0
out BECN pkts 0 in DE pkts 0 out DE pkts 0
out bcast pkts 134 out bcast bytes 8780
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
pvc create time 01:59:40, last time pvc status changed 01:55:14
R3# show frame-relay pvc
PVC Statistics for interface Serial0/0/1 (Frame Relay DTE)
Active Inactive Deleted Static
Local 1 0 0 0
Switched 0 0 0 0
Unused 0 0 0 0
DLCI = 301, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE = Serial0/0/1
input pkts 158 output pkts 22 in bytes 11156
out bytes 2240 dropped pkts 0 in pkts dropped 0
out pkts dropped 0 out bytes dropped 0
in FECN pkts 0 in BECN pkts 0 out FECN pkts 0
out BECN pkts 0 in DE pkts 0 out DE pkts 0
out bcast pkts 2 out bcast bytes 160
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
pvc create time 01:57:20, last time pvc status changed 01:56:19
d. Issue the show frame-relay route command on FR to verify that status of the Frame Relay map
statements.
FR# show frame-relay route
Input Intf Input Dlci Output Intf Output Dlci Status
Serial0/0/0 103 Serial0/0/1 301 active
Serial0/0/1 301 Serial0/0/0 103 active
e. Issue the show frame-relay map command on R1 and R3 to display a summary of the static and
dynamic mappings of Layer 3 addresses to DLCIs. Because Inverse ARP has been turned off, there are
only static maps.
R1# show frame-relay map
Serial0/0/0 (up): ipv6 FE80::3 dlci 103(0x67,0x1870), static,
broadcast,