Datasheet

Lab – Configuring Frame Relay and Subinterfaces
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 5 of 38
Active Inactive Deleted Static
Local 0 0 0 0
Switched 0 1 0 0
Unused 0 0 0 0
DLCI = 103, DLCI USAGE = SWITCHED, PVC STATUS = INACTIVE, INTERFACE = Serial0/0/0
input pkts 0 output pkts 0 in bytes 0
out bytes 0 dropped pkts 0 in pkts dropped 0
out pkts dropped 0 out bytes dropped 0
in FECN pkts 0 in BECN pkts 0 out FECN pkts 0
out BECN pkts 0 in DE pkts 0 out DE pkts 0
out bcast pkts 0 out bcast bytes 0
30 second input rate 0 bits/sec, 0 packets/sec
30 second output rate 0 bits/sec, 0 packets/sec
switched pkts 0
Detailed packet drop counters:
no out intf 0 out intf down 0 no out PVC 0
in PVC down 0 out PVC down 0 pkt too big 0
shaping Q full 0 pkt above DE 0 policing drop 0
connected to interface Serial0/0/1 301
pvc create time 00:00:53, last time pvc status changed 00:00:53
PVC Statistics for interface Serial0/0/1 (Frame Relay DCE)
Active Inactive Deleted Static
Local 0 0 0 0
Switched 0 1 0 0
Unused 0 0 0 0
DLCI = 301, DLCI USAGE = SWITCHED, PVC STATUS = INACTIVE, INTERFACE = Serial0/0/1
input pkts 0 output pkts 0 in bytes 0
out bytes 0 dropped pkts 0 in pkts dropped 0
out pkts dropped 0 out bytes dropped 0
in FECN pkts 0 in BECN pkts 0 out FECN pkts 0
out BECN pkts 0 in DE pkts 0 out DE pkts 0
out bcast pkts 0 out bcast bytes 0
30 second input rate 0 bits/sec, 0 packets/sec
30 second output rate 0 bits/sec, 0 packets/sec
switched pkts 0
Detailed packet drop counters:
no out intf 0 out intf down 0 no out PVC 0
in PVC down 0 out PVC down 0 pkt too big 0
shaping Q full 0 pkt above DE 0 policing drop 0
connected to interface Serial0/0/0 103
pvc create time 00:00:16, last time pvc status changed 00:00:16
b. Issue the show frame-relay route command. This is the Layer 2 route that Frame Relay traffic takes
through the network. (Do not confuse this with Layer 3 IP routing.)