Datasheet

Lab – Configuring SNMP
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 5 of 20
b. At this point, you may notice that the PowerSNMP Free Manager is receiving notifications from R1. If it is
not, you can try to force a SNMP notification to be sent by entering a copy run start command on R1.
Continue to the next step if it is unsuccessful.
Step 3: Discover SNMP agents.
a. From the PowerSNMP Free Manager on PC-A, open the Discover > SNMP Agents window. Enter the IP
address 192.168.1.255. In the same window, click Properties and set the Community to ciscolab and
the SNMP Version to Two, and then click OK. Now you can click Find to discover all SNMP agents on
the 192.168.1.0 network. The PowerSNMP Free Manager should find R1 at 192.168.1.1. Click the
checkbox and then Add to add R1 as an SNMP agent.