Datasheet

Lab – Troubleshooting Basic Frame Relay
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 7 of 16
Routing for Networks:
10.1.0.0/30
192.168.1.0
Routing Information Sources:
Gateway Distance Last Update
Distance: internal 90 external 170
R3:
R3# show ip protocols
*** IP Routing is NSF aware ***
Routing Protocol is "eigrp 1"
Outgoing update filter list for all interfaces is not set
Incoming update filter list for all interfaces is not set
Default networks flagged in outgoing updates
Default networks accepted from incoming updates
EIGRP-IPv4 Protocol for AS(1)
Metric weight K1=1, K2=0, K3=1, K4=0, K5=0
NSF-aware route hold timer is 240
Router-ID: 3.3.3.3
Topology : 0 (base)
Active Timer: 3 min
Distance: internal 90 external 170
Maximum path: 4
Maximum hopcount 100
Maximum metric variance 1
Automatic Summarization: disabled
Maximum path: 4
Routing for Networks:
10.1.1.0/30
Routing Information Sources:
Gateway Distance Last Update
Distance: internal 90 external 170
b. Resolve all problems found. Record your answers below.
_____________________________________________________________________________
_____________________________________________________________________________
_____________________________________________________________________________
_____________________________________________________________________________
R1(config)# router eigrp 1
R1(config-router)# no network 10.1.0.0 0.0.0.3
R1(config-router)# network 10.1.1.0 0.0.0.3
R3(config)# router eigrp 1
R3(config-router)# network 192.168.3.0
c. Issue a show ip route command on both R1 and R3. Do any EIGRP routes display in the routing table of
R1 or R3? ______ No